Author Topic: Why wont it change to composite output.  (Read 946 times)

August 08, 2009, 01:42:54 PM
Read 946 times

sharezone

  • Newbie

  • Offline
  • *

  • 5
Hiiii,

Im sooooooo impressed by this product, I dont have words, I swear to GOD this is the best product ever released by anyone. I can now literally swear by it. I got one and only one problem, Please WD address it and make this product ultimate hit for me.

Now I got my tele connected with WD by HDMI and projector with composite cable, now when I try to switch from HDMI to composite it ask me a question on my projector screen that "would you like to change resolution or something" either I press ok or cancel ... it goes back to HDMI which is very very very upsetting. Please can someone advise me what should I do???? is there a patch or new firmware out other then 1.0.2.07 which addresses this specific problem.

Thanks.

August 12, 2009, 08:44:13 AM
Reply #1

B5Fan

  • Full Member

  • Offline
  • ***

  • 182
You can only use 1 output at a time.  If you have something connected to HDMI, it will always default to that, no matter what you pick.  Disconnect the HDMI cable if you want to use the projector.