Author Topic: Large Drive 2T+  (Read 881 times)

May 23, 2013, 05:23:11 PM
Read 881 times

anishome

  • Newbie

  • Offline
  • *

  • 1
I just upgrade my firmware from version 104.17_V to the latest and greatest, now one of my attached 2T hard drive is visible but saying itís empty. Before this upgrade I can easily use this drive.
I did try rollback but if only roll me back to version 1.06.15_V. this too did not allow me access to my hard drive.
Is there a way I can used my 2T hard drive with the latest firmware
Thanks

June 23, 2013, 12:15:26 AM
Reply #1

sircamjim

  • Newbie

  • Offline
  • *

  • 2
Hi. I'm here to find some advice on a big HDD too. It would be useful if you tell what whas the FW you could use your HDD, if you are using MBR or GPT in your HDD (GPT is needed in HDDs biger than 2TB but it's not supported by older systems) and, I suppose you are using a USB 2.0 connection. You may try to use MBR and see it it works. I'm searching for that info but I don't find it but that may be the reason to your problem (and maybe mine too, my 1gen don't recognize my new 4TB USB 3.0 Seagate wall powered) Good luck!